EN
34
Operation
Preparing for Use
Before rst use, please charge the appliance for 4-5 hours (refer to “Charging Instructions” for details).
* Based on results from Tineco lab tests. Lab temperature 39.2°F (4°C) ~ 104°F (40°C).
Tips:
• Solution mode/ Water Only mode:
Appliance starts with Solution mode by
default. Power on while the appliance is
upright, long-press for 3s to switch
between the two modes.
• Switch to Water Only mode:
LED Loop: Red → Blue (use water only)
• Switch to Solution mode:
LED Loop: Blue → Red (use cleaning solution)
Press the button and the appliance will start
in AUTO mode by default. Press it again to turn
off the appliance. Switch between AUTO and
MAX mode by pressing the button.
e
The appliance will stop working when put uprightly
and start running again when you recline.
* Do not recline more than 142° to protect
against water leakage.
Place the appliance on the charging base
vertically after use for recharge and storage.
Note:
• Selecting the appropriate mode depending on the CWT contents is vital for maximum dirt detection
effectiveness.
• Do not vacuum foamed liquid.
• To vacuum water left on the surface, the appliance will switch off in 3 seconds after power off.
Stop Working Start Again
To Next Page
Loading...
Need help?
General
