Tineco FLOOR ONE S5 Series User Manual

EN
44
Troubleshooting
Problem Possible cause Solution
The appliance does not turn on Auto protection for overheating Restart after cooling down
Weak suction
The dry lter is not installed, or
the dry lter is dirty
Install the dry lter or clean
and allow it to dry completely
Brush roller tangled
indicator blinking
Voice prompt:
1.
Please clean the brush
roller
2.
Please install the
brush roller correctly
1. The brush roller is blocked
2.
The brush roller is not
installed
1. Remove blockages
2. Install brush roller correctly
WiFi indicator is off
WiFi is not connected
Follow the in-app guide to
connect to WiFi
CWT empty indicator
blinking
Voice prompt:
Clean Water Tank empty,
please rell water and
cleaning solution
CWT is empty Rell CWT
DWT full indicator
blinking
Voice prompt:
Please clean Dirty Water
Tank
The dirty water in DWT has
reached the MAX line
Empty the dirty water and
then reinstall the DWT
All lights off in operation
Battery overheat or malfunction
Cool the appliance down and
restart
Battery level indicator
blinking
Voice prompt:
Low battery, please
charge
Low battery
Charge the appliance, or
restart
LED loop illuminates red
Voice prompt:
Please begin self-
cleaning cycle
Dirt sensor malfunction or
blocked
Remove blockages, clean the
debris channel, or restart
Self-cleaning icon
blinking
Brush roller is dirty Start self-cleaning
Power indicator
blinking
Motor malfunction Contact Customer Service
Note:
If the above troubleshooting guide fails to provide a solution, please visit our website
www.tineco.com for further support.

Tineco FLOOR ONE S5 Series Specifications

General

Type	Cordless Wet/Dry Vacuum Cleaner
Battery Life	Up to 35 minutes
Self-Cleaning	Yes
Charging Time	4 hours
Smart Display	Yes
HEPA Filtration	Yes
Weight	4.5 kg
Smart Sensor Technology	iLoop Smart Sensor
Water Tank Capacity	0.8 L (depending on model)
Dirty Water Tank Capacity	0.7 L (depending on model)
Battery Voltage	21.6V (depending on model)