Tineco FLOOR ONE S5 STEAM Series User Manual

EN
18
Troubleshooting
Problem Possible cause Solution
The appliance does not turn on
The power cord is not plugged
in, or the socket is not
energized
Ensure that the socket is
energized and the power cord
is plugged in
Weak suction
The dry lter is not installed, or
the dry lter is dirty
Install the dry lter or clean
and allow it to dry completely
The brush roller is not installed Install brush roller correctly
Brush roller tangled
indicator blinking
Voice prompt:
Please clean the brush
roller
The brush roller is blocked Remove blockages
CWT empty indicator
blinking
Voice prompt:
Clean Water Tank empty,
please rell water and
cleaning solution
CWT is empty Rell CWT
DWT full indicator
blinking
Voice prompt:
Please clean Dirty Water
Tank
The dirty water in DWT has
reached the MAX line
Empty the dirty water and then
reinstall the DWT
LED loop illuminates red
Voice prompt:
Please begin self-
cleaning cycle
Dirt sensor malfunction or
blocked
Remove blockages, clean the
debris channel, or restart
Self-cleaning icon
blinking
Brush roller is dirty Start self-cleaning
Note:
If the above troubleshooting guide fails to provide a solution, please visit our website
www.tineco.com for further support.

Tineco FLOOR ONE S5 STEAM Series Specifications

General

Steam Cleaning	Yes
Cordless	Yes
Cleaning Modes	Auto, Max, Steam
Display	LED Display
Battery Type	Lithium-Ion
Runtime	35 minutes
Charge Time	4 hours
Smart Features	iLoop Smart Sensor Technology, App Connectivity
Noise Level	78 dB
Special Features	Self-Cleaning System
Included Accessories	Cleaning Tool