8
EN
Operation
Preparing for Use
Before the rst use, please charge the appliance for 3-4 hours (refer to “Charging Instructions” for
details).
* Based on results from Tineco lab tests. Lab temperature 39.2°F (4°C) ~ 104°F (40°C). Use directly
when you just need to absorb water; add water/solution when you need to deep clean the oor
(refer to “Filling Clean Water Tank Operation” for details).
Switch ON to start the machine.
Press Spot button for spot mode to remove tough spots
and stains with higher speed and stronger spray.
Squeeze the Solution trigger when moving backward to
spray liquid as needed.
* Overlap strokes by one inch to help prevent streaking, it
will pick up dirty water during cleaning.
<144°
Do not recline the appliance over than 144° to against
water leakage.
Place the appliance on the storage tray vertically after use.
Note:
• Do not use for absorbing foam liquid.
• It takes about 5 mins to dry the oor in normal mode/8 mins in Spot mode, depending on cleaning
environment.
• To dry the oor faster and avoid over wetting, please release the trigger after each spray of liquid.
To Next Page
Loading...
Need help?
General
