EN
10
Battery Installation
Press the battery release button, and remove
the battery.
To replace, slide the battery into the slot at the
base of the main body. The battery will click into
position when correctly tted.
Wall-mounted Dock Installation
5.9"
(15cm)
1. Install the accessory bracket to the rail of the wall-mounted dock and push the clip into the slot to
complete the assembly.
2. Stuck the power cord onto the slot behind the wall-mounted dock. Start from the plug end and
reserve about 5.9” (15cm) power cord to ensure that the plug can reach the charging outlet.
3. Install the wall-mounted dock to the wall with the nails provided by Tineco.
Determine the best wall location for mounting the
dock. We recommend placing it 47.25” (120cm)
from the lower screw hole to the oor (may need
to be adjusted based on the actual situation).
47.25"
(120cm)
Warning:
• Ensure the wall surrounding the mounting area is free of gas, water pipes, electrical cables and wires.
• To avoid the dock falling, ensure it is rmly installed.
To Next Page
Loading...
Need help?
General
