Copyright © 2011
Page: 5
Motz-Computer
Service und Vertriebs GmbH
Pfennigbreite 20 – 22
D-37671 Höxter
Germany
1. Preview
TIPES
MC1100 clock is based on modern radio and computer technology developments and offers a
variety of advantages for you as well as for your club.
• Automatic pigeon identification for up to 500 birds
• Automatic basketing and clocking capability for up to 500 birds
• Up to 50 liberation points programmable
• Print out of race entry form and clock roll on serial printer during clocking the birds via reading
unit or club unit.
• Automatic satellite based clock setting at the club and automatic time adjustment for your local
time
• Additional Battery-Backup-adaptor enables you to connect a 12-volt-backup supply with
automatic switch-over in case of main power interruption
• Full graphic display for more and detailed information
• Continuously clocking
• Up to 4 traps can be connected at the USTB (Universal Serial TIPES Bus) Interface
• Fully compatible to older versions of TIPES systems.
Safety instructions and precautions
The manufacturer cannot be held responsible for any damage which is incurred by not using TIPES
in compliance with the following safety instructions.
First check if your supply voltage is the same as that written on the type plate on the bottom of your
TIPES
reading unit. Use only original TIPES components.
TIPES
does not contain any parts that can be repaired by the user. Any attempt to open one of the
TIPES
units is made visible as the units are sealed. Please note that destroyed seals make all stored
race data invalid. The units may only be opened by authorized TIPES
service personnel.
For system setup refer to this manual and to the mounting instructions for the electronic trap. For
setup of the race office please refer to the master unit manual.
To switch off TIPES
completely you must disconnect the MC1100 from
the power supply. If the MC1100 is connected to a reading unit, then
power off of this.
Protect the MC1100 clock and all other TIPES units as well as all connectors from rain and moisture.
Make sure that the electronic trap is not placed in a puddle during rain. The trap installation should
provide proper draining of water.
Do not place the MC1100 clock close to sources of heat such as radiators etc.
The MC 1100 clock and other TIPES units except traps should only be used inside a building. Do not
use these units immediately after moving them from a cold to a warm location. Before powering, on
allow at least 60 minutes to acclimatize.
Any change or modification of the TIPES
system or a component of this system requires explicit
written approval of the manufacturer. Unauthorized modification does abolish the general operation
agreement.
To Next Page
Loading...
Need help?
General