Tirol TK110 - Move Alarm Setting

When the unit speed is over 70km/h, it will send message “speed alarm!” to the
admin number .
Over-speed Alarm canceling ：
Command ：nospeed123456
Reply：nospeed ok
5.4. move Alarm setting (It works only in getting gps signal, the scope is a circle
that radius 200meters)
Command：move123456
Reply：move ok
E.g：
move alarm Canceling:
Command：nomove123456
Reply：nomove ok
5.5 Terminal (local) Time Setting(factory setting GMT 0)
Command：time +space+zone123456+space +local time zone
Reply：time ok!
E.g： time zone123456 1