Make sure to never raise the rear of the cabin higher than the front.
This could result in the alcove resting on the roof of your carrier
vehicle.
• Start lowering the cabin using the rear supports.
• Use the option to extend all supports at the same time.
Press keys 1, 2, 7 or 8 of your Happijac remote control and hold them in order to individually extend
the supports.
Every support must touch the ground.
Press and hold key 6 of your Happijac remote control. The cabin is raised on all four supports at the
same time.
Alternatively, using the special function keys:
Press key 1 twice and hold it in order to extend both supports on the left side.
Press key 2 twice and hold it in order to extend both supports on the right side.
Press key 3 twice and hold it in order to retract both supports on the left side.
Press key 4 twice and hold it in order to retract both supports on the right side.
Once the supports are completely retracted, loosen cotter pin 1, pull out bolt 2 and insert attachment
part 3 into the support. Stow pads 4 in the vehicle.
To Next Page
Loading...