2 3
Atlas
®
9 CO
2
Controller with Remote Sensor
• Warnings & Cautions
• Atlas
®
9 CO2 Controller Overview
• Factory Settings
• Operation Instructions
• Controller Specifications
• Controller Diagrams
• Installation Examples
• Warranty Information
• Service and Repair Program
Warnings & Cautions
SULFUR VAPORIZER WARNING
If a sulfur vaporizer is used, first remove the remote sensor from area or turn the controller OFF
and cover the remote sensor probe with a protective plastic bag. Remove the bag before turning
the power back on.
Note: Failure to protect the sensor during sulfur use will result in damage to the infrared CO
2
sensor and void warranty.
• Read all instructions before operating controller.
• Do not put your controller in an area where it can get wet or sprayed.
• Mount your controller securely to the wall.
• When using “bug bombs” in area, cover controller completely to avoid corrosion.
• There are no serviceable parts in controller. Do not attempt to repair the unit.
• Breaking “warranty” seal will void your warranty.
• Do not put paper clips, tools, etc. into unit. Possible electrocution may occur.
• Plug controller into surge protector to avoid potential damage to the unit.
• Make sure to verify your power source prior to plugging controller into outlet.
• Check that all equipment that will be activated by this controller is the proper voltage.
• Verify that your equipment does not exceed a total of 10 amps.
• This controller is designed for inside use only.
• Avoid placing the controller near heat generating sources.
• Use caution when operating controller in extremely humid environments.
• Do not use controller for purposes other than the unit was designed to function.
• Use controller within defined environmental specifications.
• Ask your Dealer for tips and techniques regarding the use of this controller.
• Be conscientious when disposing of any products.
To Next Page
Loading...
Need help?
General
