2 3
Complete Digital Environmental Controller
• Warnings and Cautions
• Factory Settings
• Complete Digital Environmental Controller (CDEC) Overview
• Instructions for Operation
• Error Codes
• Controller Specifications
• Controller Diagrams
• Installation Options
• Installation Example
• Warranty Information
• Service & Repair Program
Warnings & Cautions
SULFUR VAPORIZER WARNING
If a sulfur vaporizer is used, first remove the remote sensor from area or turn the controller OFF
and cover the remote sensor probe with a protective plastic bag. Remove the bag before turning
the power back on.
Note: Failure to protect the sensor during Sulfur use will result in damage to the
infrared CO2 sensor and void warranty.
• Read all instructions before operating controller.
• Do not put your controller in an area where it can get wet or sprayed.
• Mount your controller securely to the wall.
• When using “bug bombs” in area, cover controller completely to avoid corrosion.
• There are no serviceable parts in controller. Do not attempt to repair the unit.
• Breaking tamper proof seal will void your warranty.
• Do not put paper clips, tools, etc. into unit. Possible electrocution may occur.
• Plug controller into surge protector to avoid potential damage to the unit.
• Confirm that your power source is 120 Volts/15 Amps prior to plugging controller into outlet.
• Check that all equipment that will be activated by this controller is the proper voltage(s).
• Verify that the equipment you are controlling does not exceed a total of 14.5 amps.
• This controller is designed for “inside use” only.
• Avoid placing the controller near heat generating sources such as a CO
2
Generator.
• Use caution if operating controller in extremely humid environments (90% and above).
• Do not use controller for purposes other than the unit was designed to function
• Use controller within defined environmental specifications.
• Ask your Dealer for tips and techniques regarding the use of this controller.
• Be conscientious when disposing of any products.