Titan Dynamics
Titan Dynamics Webpage
Visit our Facebook page
Join our Discord server
Page
16
of
30
Polycarbonate, PETG or other high-temp filament should be used for the motor
mounts and wing bay covers.
• High temp Polycarbonate or PETG parts should be triple wall and high infill (25%).
We recommend using version 5.2.2 of Ultimaker Cura. You can find many instructions
and a suitable LW-PLA profile at this link.
4.2: Part Orientation
It is necessary to orient each part correctly on the build plate to avoid disconnected
overhangs. Take care when doing this as the entire model is designed to be printed with
no supports. If you orient some parts wrong, the print will fail. It may also be necessary
to rotate and carefully position some parts to fit within the build area on smaller
printers.
Examples for part orientation to avoid using supports:
To Next Page
Loading...
