16
Most problems are easy to fix. Consult the troubleshooting table below for common problems and their
solutions.
WARNING
Disengage PTO, shut down the tractor engine, remove the key, wait for all moving parts to come to a
complete stop, disconnect the PTO shaft from the tractor, then wait five minutes before performing any
maintenance procedure or inspection on the trimmer.
1. Cord need to be replaced.
2. Tractor speed too fast.
1. Arm or wheel adjustment is off. Check for frame level or height
of hydraulic arms on tractor
1. Inspect cords.
2. Check belt tension/wear.
3. Check PTO rotation
The trimmer head
won’t spin or lacks
power
1. Check for proper alignment of the V-belt.
2. The belt may be worn or frayed; if so, replace it.
To Next Page
Loading...
