8
STEP 6: ATTACH WHEELS
Attach sleeve (#50) and wheel (#46) to the wheel axle, then attach clutch assembly to the wheel
axle using hex bolt M8x60 (#60), clutch spring (#55), large flat washer Ø8 (#27) and nylon lock
nut M8 (#11). Turn the nylon lock nut M8 to adjust the spring tightness to the right position.
STEP 7: ADJUST THE DISCHARGE PLATE
Adjust the discharge plate assembly by moving it up and down to ensure that the gap between
the discharge plate and the roller is between 3-5mm. Tighten the bolt to lock the discharge plate
assembly.
To Next Page
Loading...
