Why does my Titan Speeflo Hydra M 2000 spray tip stop up frequently?
Your Titan Paint Sprayer's spray tip may be stopping up frequently because particles too large for the spray tip are passing through the filter or gun screen. To resolve this, try using a 100 mesh gun screen instead of a 50 mesh screen for small spray tips. Also, use a 100 mesh screen in the pump filter and strain the paint.
What to do if my Titan Speeflo Hydra M 2000 Paint Sprayer gun does not spray any fluid?
If your Titan Paint Sprayer gun isn't spraying fluid, it could be due to several reasons. First, inspect for a suction hose leak. Second, check the fluid supply. Third, remove, clean, and inspect the foot valve. Fourth, clean the filters or tip. Finally, clean and inspect the pump ball check valve.
How to fix tails when using Titan Paint Sprayer?
If you are experiencing tails when using your Titan Paint Sprayer, it could be due to inadequate fluid delivery or the fluid not atomizing correctly. To fix this, try increasing the fluid pressure, changing to a smaller tip orifice size, reducing fluid viscosity, reducing hose length, cleaning the gun and filter(s), or reducing the number of guns using the pump.
Why does my Titan Paint Sprayer have irregular flow of material?
Irregular flow of material, where one stroke is faster than the other, in your Titan Paint Sprayer can occur if the packings are worn, valve balls are not seating properly, or there's a restriction in the siphon system. Check the siphon hose assembly to ensure no air is entering, and recheck all threaded fittings for leakage.
Why is my Titan Paint Sprayer spitting?
Spitting in your Titan Paint Sprayer may be caused by air in the system or a dirty gun. Inspect for a siphon hose leak and disassemble and clean the gun.
Why does the Titan Paint Sprayer spray pattern change with pump cycle?
If the spray pattern of your Titan Paint Sprayer changes with the pump cycle, it is likely due to restrictions in the fluid system. Check the gun and pump filter screens, and always clean the screens before they load up.
What to do if my Titan Speeflo Hydra M 2000 Paint Sprayer gun drips?
If your Titan Paint Sprayer gun drips or throws a drop at the beginning or end of the spray pattern, the needle may not be seating correctly, or the spring tension might need adjustment. The needle-orifice combination should be factory relapped. Also, the needle packing may be too tight, so loosen it as much as possible without leakage. Turn the adjusting screw on the back of the gun clockwise to increase tension, or use the green HP spring Part # 701-098.
General| Brand | Titan |
|---|---|
| Model | Speeflo Hydra M 2000 |
| Category | Paint Sprayer |
| Language | English |
To Next Page