Titan TTCSP49 - Maintenance Schedule and Components

46
TTCSP49
In more detail . . .
Cleaning the guide bar
> Disassemble the guide bar (2) and saw chain in reversed order from assembly.
> Remove any dirt accumulated inside the guide bar slot using the putty knife (not
provided) (Fig. 39).
39
> Use a damp, lint-free cloth to clean the surface.
> Wipe the surface with a dry cloth afterwards.
Maintenance table
Inspect and maintain this product regularly based on below maintenance table. Keep
the chain saw in good working condition during maintenance.
Part Task Before/after
each use
Every 10 hours
of operation
Every 25 hours
of operation
Overall
check X
clean X
Cylinder
ns
clean X
Spark plug
check X
clean X
replace whenever necessary
Saw chain
check X
lubricate X
clean X
sharpen whenever necessary
replace whenever necessary
Guide bar
check X
lubricate X
clean X
replace whenever necessary
Care and maintenance