Titan TTHTP26 - Care and Maintenance

28
TTHTP26
In more detail . . .
> After cutting the sides proceed to the top (Fig. 25). Try to keep the cutting device at
an angle of approximately 15° to the cutting surface.
> Cut in stages if the area being cut is particularly long to achieve a better result;
smaller trimmings will allow for easy composting.
2624 25
1
2
15
15
°
°
NOTE: When shaping it is recommended to achieve a trapezoidal shape (Fig. 26).
A trapezoidal cut corresponds to the natural growth of plants and results in
optimal hedge growth, as it will expose more light to the lower end of the hedge.
After use
1. Stop the engine, disconnect the spark plug wire and let the engine cool down.
2. Check, clean and store the equipment as described below.
WARNING! The cutting device (1) continues to move for some time after
the engine has been switched off. Wait until the cutting device comes to a
complete stop before setting the equipment on the ground.
Operation / Care and maintenance
5059340124346-TTHTP26-GB-V01.indd 285059340124346-TTHTP26-GB-V01.indd 28 18/9/2020 9:55 AM18/9/2020 9:55 AM