37
TTHTP26
In more detail . . .
Problem Possible cause Solution
Engine does not
reach
the maximum
speed.
Air lter is soiled? Clean the air lter.
Incorrect fuel or incorrect
mixture?
Stop the engine, empty tank, then
ll up with the correct mixture of
fuel to oil (40:1).
Carburetor setting not
correct?
Have a qualied person adjust the
carburetor.
Engine starts
but does not
accelerate.
Engine is not warmed up? Allow engine to warm up at idle
speed for 2-3 minutes.
Bad cutting
performance.
Cutting device is worn? Have a qualied person sharpen or
replace the cutting device.
Thickness of the branches
exceeds capacity.
Only cut branches with a diameter
of maximum 20 mm.
Excessive
vibration/noise or
smoke.
Cutting device damaged? Have a qualied person replace
the cutting device.
Nuts on the cutting device
loosen?
Stop the engine and re-tighten the
loosen nuts.
Incorrect fuel or incorrect
mixture?
Stop the engine, empty tank, then ll
up with the correct mixture of fuel to
oil (40:1).
Recycling and disposal
1.
Old equipments are potentially recyclable and do not, therefore, belong in your
household rubbish. You are requested to assist us and our contribution to saving
resources and protecting the environment by handing in this equipment to an equipped
collection centre (if there is one available).
2.
Petrol, oil, used oil, a mixture of oil and petrol and objects soiled with oil e.g. cleaning
cloths do not belong in the household rubbish. Dispose of oil-contaminated items in
accordance with the local guidelines and hand them in at recycling centres.
3.
The equipment comes in a package that protects it against damage during shipping.
Keep the package until you are sure that all parts have been delivered and the
equipment is operating properly. Recycle the package afterwards.
Troubleshooting / Recycling and disposal
5059340124346-TTHTP26-GB-V01.indd 375059340124346-TTHTP26-GB-V01.indd 37 18/9/2020 9:55 AM18/9/2020 9:55 AM
To Next Page
Loading...
Need help?
General
