35
TTHTP26
In more detail . . .
Long term storage
NOTE: Risk of equipment damage!
>
If you are not going to use the equipment for a while, remove the fuel from
the equipment. This way, you will prevent a gumming-up of the engine and
of the grease pump.
> Store the equipment in a dry place and far away from possible sources of
ignition such as ovens, gas thermostats, etc.
1.
Empty the fuel tank (12) using a fuel pump if you are not going to use the equipment
for more than 1 day, and especially before winter storage.
2.
Start the engine and let it run until the engine stops by itself (see “Starting the engine”).
3. Let the engine cool down (approx. 5 min).
4. Unplug the spark plug wire (19).
5. Let a teaspoon of clean two-stroke engine oil run into the combustion chamber.
6.
Pull the recoil starter handle slowly several times in order to coat the internal
components with the engine oil.
7. Ret the spark plug wire (19).
Transportation
1.
Stop the engine and disconnect the spark plug wire (19) before transporting the
equipment.
2. Attach the cutting device transport guard (18).
3. Always carry the equipment on its handles surfaces.
4. Protect the equipment from any heavy impact or strong vibrations which may occur
during transportation in vehicles.
5.
Secure the equipment to prevent it from slipping or falling over, loss of fuel, damage
and injury.
If you are transporting the equipment in a vehicle:
> Let the equipment cool down.
> Empty the fuel tank (12).
>
Secure the equipment against slipping using bungee cords (not provided) and vehicle’s
transportation hooks.
Care and maintenance
5059340124346-TTHTP26-GB-V01.indd 355059340124346-TTHTP26-GB-V01.indd 35 18/9/2020 9:55 AM18/9/2020 9:55 AM
To Next Page
Loading...
Need help?
General
