EN
27
In more detail...
TTI821GGT by TITAN
Operation
7. Ensure the cutting device remains clean and free from off-cuts that may
cause it to jam. Check regularly. Release the on/off switch (3) and remove
the battery pack before checking.
8. Trim longer grass in stages; do not cut long grass in one cut (Fig. 17). For the
best results, cut longer grass in steps (Fig. 18).
Fig. 17 Fig. 18
Fig. 19
General operation
1. Make sure that the knife protector (11d) is removed, the plant protector (12) is
pulled out and the battery pack (16) is assembled before operation
2. Adjust the main handle (1) angle to 90° or 180° for edging (Fig. 19).
Tips
1. For best results, do not cut wet grass because it tends to stick to the cutting
head and guard, prevents proper discharge of grass trimmings, and could
cause you to slip and fall.
2. Do not allow the spool cover to drag on the ground or other surfaces.
3. Pay special attention when performing the work close to trees and bushes.
The cutting head could damage sensitive bark, and damage fence posts.
4. Pull the plant protector out to avoid bringing the cutting device into contact
with hard objects such as walls and kerbstones (Figs. 20, 21).
To Next Page
Loading...
Need help?
General
