EN
28
In more detail...
TTI821GGT by TITAN
Operation
Tips
Fig. 20 Fig. 21
NOTE: The trimming line will wear faster and require more
replacement if cutting is done along sidewalks or other abrasive
surfaces or heavier weeds are being cut.
NOTE: While trimming, the cutting device is possible to be blocked by
grass or unevenly ground. So the product will turn off automatically
due to over current. Therefore release the on/off switch for over 3s
and then press down again to go on with trimming.
Line feeding
During use, the tip of the trimming line will get shorter due to wear and the
trimming line may break. Regularly check the condition of the trimming line (13d)
and adjust if necessary.
WARNING! Always switch the product off, remove the battery
pack and let the product cool down before performing inspection,
maintenance and cleaning work!
NOTE: This product is equipped with an auto-feed head. Do not bump
the trimmer head on the ground as this would damage the product.
Manual feeding
1. Turn trimmer head (13) upside down.
2. Press the release push button (13g) while pulling on the trimming line (13d).
The trimming spool (13c) will release the trimming line (Fig. 22).
To Next Page
Loading...
Need help?
General
