32
TTL758CHN
In
more
detail...
EN
Operation
3. To avoid kickback:
• Saw with guide bar at a at angle.
• Never work with a loose, widely stretched or the heavily worn out
saw chain.
• Ensure the saw chain is sharpened correctly.
• Never saw above shoulder height.
• Never work with the tip of the guide bar.
• Always hold the product rmly with both hands.
• Always use a low kickback chain.
• Apply the spiked bumper for leverage.
• Ensure correct chain tension.
• Do only cut with the motor at high speeds.
• Do not let the tip of the guide bar (4) contact a log, branch, or
any other obstruction which could be hit while you are operating
the product.
• Follow manufacturer’s sharpening and maintenance instructions
for the saw chain.
• Only use replacement guide bars and saw chains specied by
the manufacturer or equivalent replacements.
WARNING! Most ‘kickback’ accidents happen during limbing!
Pay close attention to the position of the ‘kickback’ zone
of the bar when you are ‘limbing’ branches that are under
tension.
your thumbs and ngers encircling the handles. A rm grip will
help you reduce ‘kickback’ and maintain control of the product.
6). You should carefully read all safety warnings and user
instructions before attempting to operate this product.
To Next Page
Loading...
Need help?
General
