Instruction manual
30
Please observe the safety information of the enclosed information sheet.
Start-up
In order to put the products into operation properly, read this instruction manual, including the safety information,
fully and carefully before use. The products should only be operated on a stable, even surface. Connected cables
should be laid safely here (Caution! Trip hazards).
- Turn the BALANCE control or Bass Treble (depending on the device) to the centre position.
- Turn the VOLUME control (MIC, CD or TAPE) to the min. position.
- Plug the accompanying power cable into the power supply connector on the side.
- Connect the mains plug to the 230 V~/50 Hz power supply.
- Switch the TLS
®
devices on or off using the POWER switch.
- The switch is located above the power cable input on the side of the enclosure.
To Next Page
Loading...
