8
4. SOFTWARE STARTUP
The WT-D5800 Maintenance Software will start up on the main screen when the short cut icon on
the desktop is clicked after installation.
[Main screen (Initial screen)]
1
2
1. Connect/Disconnect button
Clicking the Connect button will detect the
receiver that is connected to the PC through
the USB cable and start connecting. Once
connecting starts, the button will be switched to
the Disconnect button.
Clicking the Disconnect button will stop the
connection to the receiver. Once connecting
stops, the button will be switched to the Connect
button.
2. Connection status display
The screen will display “Disconnected” when it’s
not connecting to the receiver.
The screen will display “Connected” when it’s
connecting to the receiver.
Note
See p. 10 for the Connected display, p. 29 for the Disconnected display.
To Next Page
Loading...