Toa WT-D5800 - How to Use Channel Scan Function

12
6.2. How to Use Channel Scan Function
Note
The Channel Scan function cannot be used while the Walk-Test, storing Background Log, or Spectrum Scan is
executed, or while the detailed settings of the FBS function are shown.
Step 1. Turn off all the microphone switches.
Step 2. Select a receiver that is connected from the list on the main screen and click on the Channel Scan
button.
[Main Screen]
2
Displays the Channel Scan screen.
[Channel Scan Screen]
5
7
6
3
4
Step 3. Select a bank to be scanned.
Step 4. Click the check box to set the Peak Hold function if necessary.
Step 5. Click on the Start Scan button.
Channel Scan will start.