INSTALLATION 27
5
ENOW00945-0
z Please inspect whether there is a loosen-
ing of the clamp screw or mounting bolts
before departure.
z Loosening may cause a dangerous situa-
tion, such as loss of control.
PT type
1. Set the outboard motor to appropri-
ate position.
2. Secure the clamp brackets to the
transom board using bolts, flat wash-
ers and nylon locking nuts.
1. Bolt (12 × 105)
2. Washer (small diameter)
3. Nylon locking nut
4. Washer (large diameter)
ENOW00008-2
z Install upper mounting bolts from the
boat side. Exposing threaded side of bolts
on the boat side can casue personal
injury.
z Tighten the bolts securely, otherwise the
outboard motor could fall down.
ENON00948-0
Note
z Apply sealing agent, such as silicone
sealant between the bolts and the
transom board holes before tightening
the bolts.
z Do not reuse nylon locking nut.
CAUTION
CAUTION
251
ø12.5
ø12.5
253.5
(2.0”)
(10.0”)
56
(2.2”)
1818 18
51
327
(12.9”)
(9.9”)
ENOF00613-0
To Next Page
Loading...
Need help?
General
