ENGINE OPERATION46
7
4. Insert the knotted end of the starter
rope into the notch in the flywheel
and wind the rope clockwise around
the flywheel several turns.
5. Tie a loop in the another end of the
emergency starter rope and attach
socket wrench, Both the loop and the
wrench are provided in outboard
motor box.
ENOW00860-0
Be sure to keep the harness away from the
rotation parts.
6. Be sure to install the stop switch lock
to the stop switch, and attach the
stop switch lanyard securely to the
operator or to the operator's PFD
(Personal Flotation Device.)
7. Set the control lever in the Neutral
position.
8. Pull the starter handle slowly until you
feel engagement, keep pulling till you
feel less resistance. Then pull it
quickly.
9. Once the outboard motor is started,
do not reinstall the recoil starter and
top cowl.
ENOM00043-A
ENOW00932-1
Be sure to check that cooling water is dis-
charged from the cooling water check port
during warm up.
Warm the engine at low engine speeds
for about
3 minutes : above 5°C (41°F)
5 minutes at 2000 min
-1
(rpm) : blow 5°C
(41°F)
This allows the lubricating oil to circulate
to all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
CAUTION
ENOF02522-0
ENOF02523-0
3. Warming up the engine
CAUTION
To Next Page
Loading...
Need help?
General
