TOHATSU MFS 25d User Manual

PRE-OPERATING PREPARATIONS 37
6
ENOM00126-0
Remedy
1. Reduce the speed to less than half
open throttle, and move to safe place
quickly, and stop the engine.
Check the propeller for bent or dam-
age on blades.
Consult an authorized dealer if engine
shows the same result even after
replacing propeller with a new one.
2. Move to safe place quickly, and stop
the engine until it cools down.
Check the engine oil level, and add
engine oil if necessary.
Consult your dealer if the engine oil
level is too low or too high.
3. Move to safe place quickly, and check
if cooling water is discharged from
the water check port at idle speed
and stop the engine.
Remove any foreign matter on the
gear case and propeller if necessary.
Consult an authorized dealer if no
discharge of cooling water.
4. Consult an authorized dealer.
ENOW00985-0
z Low speed ESG ON: Engine speed will be
limited to 2800 min
-1
(rpm), however you
should not continue to run engine.
z High speed ESG ON: Engine speed will be
limited to specified engine speed and
engine will run rough until throttle is
reduced.
MFS 30D: 6700 min
-1
(rpm)
MFS 25D: 6200 min
-1
(rpm)
CAUTION

TOHATSU MFS 25d Specifications

General

Brand	TOHATSU
Model	MFS 25d
Category	Outboard Motor
Language	English