INSPECTION AND MAINTENANCE72
10
ENOM00950-1
Fuse replacement
ENOW00923-1
Before replacing a fuse, disconnect the bat-
tery cable from the battery negative (-) ter-
minal first. Failure to properly remove
battery cables may cause a short-circuit.
ENOW00924-0
Never use a fuse with a rating that exceeds
the specified rating as this could cause seri-
ous damage to the electrical system.
If the fuse is blown, try to determine the
cause and respond to the problem as
simply replacing the fuse will likely be
blown again. If you are unable to respond
to the cause or the fuse continues to
blow, request an authorized Tohatsu
dealer for inspection.
1. Stop the engine and disconnect the
battery cable from the battery nega-
tive (-) terminal.
2. Remove the engine cover.
3. Remove the fuse box lid.
4. Remove the fuse for inspection. If the
fuse is blown, replace it with a fuse of
the same specified rating. The spare
fuse is supplied with the outboard
motor in the spare fuse holder.
1. Blown fuse
CAUTION
CAUTION
To Next Page
Loading...
Need help?
General
