What to do if Power T & T is inoperative in TOHATSU MFS 40A?
If the Power Trim & Tilt (T&T) is inoperative on your TOHATSU Outboard Motor, the power trim & tilt switch or the solenoid may be defective. Inspect and replace the defective switch or solenoid.
What to do for carbon deposits in the combustion chamber of TOHATSU MFS 40A?
To address carbon deposits in the combustion chamber of your TOHATSU Outboard Motor, clean the combustion chamber.
What to do if there is insufficient cooling water flow in TOHATSU MFS 40A?
To resolve insufficient cooling water flow in your TOHATSU Outboard Motor, inspect and clear the cooling water passages.
What to do if there is low oil pressure or level in TOHATSU MFS 40A Outboard Motor?
If you have low oil pressure or level in your TOHATSU Outboard Motor, check the oil level and pump functionality.
Why does my TOHATSU Outboard Motor engine run erratically?
If your TOHATSU Outboard Motor engine runs erratically, begin by checking the fuel system connections to ensure they are correct. Inspect the fuel line for any air leaks and repair as needed. Replace any deformed or damaged fuel hoses. Ensure the air vent on the fuel tank is open. Clean or replace a clogged fuel filter or fuel pump. If the fuel pump is malfunctioning, have it serviced or replaced. Clean any dirt or soot from the spark plug, and inspect and rectify any spark issues. Check the electrical components and wiring connections for any issues. Finally, replace the spark plug if it's not the specified type.
General| Horsepower | 40 HP |
|---|---|
| Gear Ratio | 2.08:1 |
| Number of Cylinders | 3 |
| Displacement | 866 cc |
| Fuel System | Electronic Fuel Injection |
| Starting System | Electric |
| Shaft Length | 20 inches |
| Fuel Type | Unleaded Gasoline |
| Max. RPM | 6000 RPM |
| Alternator Output | 12V |
| Engine Type | 4-Stroke |
Proper use of the engine stop switch lanyard for safety.
Procedures and safety precautions for securely mounting the motor on a boat.
Critical information on safe handling of gasoline and its hazards.
Procedures for safely filling the fuel tank, including precautions.
Instructions for filling engine oil to the correct level and safety warnings.
Detailed instructions on how to safely start the outboard motor.
Safe procedures for shifting gears and accelerating the boat.
Correct procedures for stopping the engine safely and performing post-operation checks.
A table listing common problems and their potential causes.
To Next Page
