Before starting engine for the first time
after reassembling engine or off-season
storage, disconnect stop switch lock
and pull the starter handle completely
out approximately 10 times in order to
prime the oil pump.
①
Loosen the air vent screw on the
tank cap.
②
Attach the fuel connector to the
engine connector.
The arrow mark on the primer
b u l b s h o u l d b e f a c i n g t h e
engine.(Separate fuel tank)
Open the fuel cock.(Integral fuel
tank)
③
Feed fuel to the carburetor by
squeezing the primer bulb until it
is firm.(Separate fuel tank)
④
Place the shift lever in the Neutral
position.
Be sure that the shift is in neutral
when starting the engine.
This model is provided with start in
gear protection.
18
14
13
12
11
10
9
8
7
6
5
4
3
2
1
Before starting
1. Starting
Note
The engine will not start unless
the switch lock has been properly
connected into the emergency stop
switch.
ENGINE OPERATION
In case engine starts in gear, do not
start cruising. Stop engine immediately
and consult an authorized dealer.
To Next Page
Loading...
Need help?
General
