INSTALLATION22
5
1. Bottom of hull
2. Anti ventilation plate
ENOW00007-1A
z Before running test, check the boat with
maximum loading capacity. Overloading or
incorrect weight distribution of the
weight may result in boat to lose control,
even swamping or capsizing. Make sure
that there is enough distance between
bottom cowl and water surface to prevent
water from entering the engine.
z Make sure to mount the engine in correct
position. If outboard motor is mounted
incorrectly, water may intrude the engine
from openings of the bottom cowl while
cruising. Exposing the engine to such con-
dition may result in severe damage to the
engine.
z Tighten the clamp screws sufficiency,
otherwise falling down of outboard could
be happened.
ENOM00831-0
Mounting the outboard motor
1. Set the outboard motor to appropri-
ate position.
2. Tighten the clamp screws by turning
their handles.
3. Secure the outboard motor to the
boat with a rope to prevent acciden-
tal loss of the outboard motor over-
board.
ENON00930-0
Note
Do not use tools to tighten clamp screws.
Over tightening could result in damage to
the clamp screws and clamp brackets.
ENON00002-0
Note
A rope is not included in the standard
accessories.
ENOW00945-0
z Please inspect whether there is a loosen-
ing of the clamp screw or mounting bolts
before departure.
z Loosening may cause a dangerous situa-
tion, such as loss of control.
CAUTION
1
2
5−25 mm
(0.2−1 in)
ENOF01506-0
CAUTION
ENOF01507-A
To Next Page
Loading...
Need help?
General
