REMOVING AND CARRYING THE OUTBOARD MOTOR46
8
Keep the outboard motor in a vertical
position when carrying.
The optional outboard motor stand is
recommended for keeping the outboard
motor vertical both during transport and
storage.
ENOM00441-0
If the outboard motor must be laid down,
be sure to drain the remaining fuel in the
fuel line and carburetor (see page 65).
When laying down the outboard motor,
place front-side, starboard-side, or port-
side down on a cushion or any softer sur-
face shown below.
ENON00941-0
Note
When laying the outboard front-side
down, turn the clamp bracket 90° clock-
wise or anti-clockwise so that it does not
interfere with the ground. Then tighten up
the steering adjustment screw to maintain
its position (see page 48).
ENOM00072-1A
ENOW00072-0
Trailering in the tilted position may cause
damage to the outboard motor, boat, etc.
ENOW00073-A
Be sure to disconnect fuel connector except
when operating engine.
ENOF01511-1
3. Trailering
CAUTION
WARNING
To Next Page
Loading...
Need help?
General
