ENGINE OPERATION 41
7
ENOM00910-1
Spare emergency stop switch lock
(For CE marking model)
A spare emergency stop switch lock is
provided in the accessories bag.
Make sure that spare stop switch lock is
available before operating outboard
motor.
When used as described, the emergency
stop switch clip and emergency stop
switch lanyard system stops the engine if
the operator is thrown overboard. When
an operator falls into water, be sure to
use spare emergency stop switch lock.
ENOM00920-A
ENOW00870-1
Sudden steering may cause passenger(s) to
be thrown overboard or fall.
Tiller handle type
Right turn
Move the tiller handle to the left
Left turn
Move the tiller handle to the right.
ENOM00050-0
ENOW00043-1
z Adjust the trim angle when the engine is
stopped.
z Do not put hand or finger in between out-
board motor body and clamp bracket
when adjusting trim angle to prevent pos-
sible injury.
z Unsuitable trim position can cause loss of
control of boat. When testing a trim posi-
tion, run the boat slowly initially to see if
it can be controlled safely.
ENOW00044-1A
Excessive trim up or down may cause unsta-
ble boat operation, loss of control that may
leads to accident during cruising.
z For manual tilt model, If you feel the trim
is improperly positioned, stop the boat
and readjust trim angle before continuing
to cruise.
6. Steering
WARNING
ENOF00891-0
7. Trim angle
WARNING
WARNING
To Next Page
Loading...
Need help?
General
