ENGINE OPERATION36
7
ENON00501-0
Note
Choke is not necessary when the engine is
warm. Set the throttle grip to “RE-START”
position.
ENON00502-0
Note
If engine does not start with 4 or 5 times
starting operation, push the knob back and
restart.
5. Pull the starter handle slowly until you
feel engagement, keep pulling till you
feel less resistance. Then pull it
quickly. Repeat the procedure until
the outboard motor is started.
1. Slowly
2. Quickly
ENOW00064-0
Engine may be hot immediately after operat-
ing and could cause burns if touched. Allow
engine to cool down before attempting to
carry the outboard.
6. After engine starting, return the
choke knob while check the engine
speeds. if the engine speeds unstable,
pull the choke knob to operated.
7. Check the cooling water from cooling
water check port.
1. Cooling water check port
ENOM00042-F
Emergency starting
ENOW00099-
When the emergency starter rope is used for
starting engine;
z Start in gear protection does not work.
Make sure that shift is in neutral position.
If the gear is in Forward or Reverse, the
boat can start moving immediately and
may lead to accident and personal injury.
z Be careful that of your clothes or other
items do not to get caught in the rotating
parts.
z To prevent accident and injury by rotating
parts, do not re-attach flywheel cover
or recoil starter and the top cowl after
the engine has been started.
z Do not pull starter rope if any bystander is
around.
z Attach engine stop switch lanyard to
clothing or any part of body such as wrist,
arm before starting engine the outboard
motor.
1. Remove the top cowl.
CAUTION
WARNING
To Next Page
Loading...
Need help?
General
