TOHATSU MFS 6C User Manual

ENGINE OPERATION 41
7
3. Raise the outboard motor to the tilt
up position.
4. Change the thrust rod position as fol-
lowing picture.
1. Push in
2. Rise the stopper
3. Pull out
5. Reinstall the thrust rod securely.
6. Gentry lower the outboard.
ENOM00060-A
ENOW00055-0
Do not tilt up or down outboard motor when
swimmer(s) or passenger is near to prevent
them from being caught between outboard
motor body and clamp bracket in case the
outboard motor body falls.
ENOW00048-0
When tilting up or down, be careful not to
place your hand between the swivel bracket
and the stern bracket.
Be sure to tilt the outboard motor down
slowly.
ENOW00056-A
When tilting up outboard motor with fuel
joint for over a few minutes, be sure to dis-
connect fuel hose, or fuel may leak, poten-
tially catching fire.
ENOW00057-0
Do not tilt up outboard motor while engine
operates, or no cooling water may be fed,
leading to engine seizure due to overheating.
ENON00921-0
Note
Before tilting the outboard motor up, after
stopping the motor leave it in the running
position for about a minute to allow water
to drain from inside the engine.
ENOM00423-0
Tilt up
With the shift lever in Forward, fully tilt
the motor up toward you by holding the
tilt handle provided at the rear of the top
cowl. Then slightly lower the motor for
locking in the up position.
8. Tilt up and down
WARNING
WARNING
3
2
1
ENOF01238-1
WARNING
CAUTION
ENOF00441-0

TOHATSU MFS 6C Specifications

General

Brand	TOHATSU
Model	MFS 6C
Category	Outboard Motor
Language	English