12
6. OPERATION FLOW AND PARAMETER INFORMATION
6.1 Operation Flow
POWER "ON"
↓
RUN signal input(open)
Hold down ▲
▲▲
▲ and ▼
▼▼
▼ key
Hold down MODE and ▼
▼▼
▼ key simultaneously for
simultaneously for 3 seconds 3 seconds.
Press MODE key for 3 seconds.
PID Control
① Number of pattern
Step SV
proportional band
(Low temp.)
↓ Press Mode key ↓ Press Mode key ↓ Press Mode key
② Number of step
Step time
Integral time
(Low temp.)
↓ Press Mode key ↓ Press Mode key ↓ Press Mode key
③ PV correction
Step wait zone
Differential time
(Low temp.)
↓ Press Mode key ↓ Press Mode key ↓ Press Mode key
④ ℃/
selection
Step wait time ON/OFF Control
Control sensitivity
↓ Press Mode key ↓ Press Mode key (Low temp.)
⑤ Type of Control
Step Time Signal ↓ Press Mode key
ON time
Low Temp. area
↓ Press Mode key ↓ Press Mode key High limit
⑥ Type of Input/
Step Time Signal ↓ Press Mode key
Output OFF time To
. or
↓ Press Mode key ↓ Press Mode key PID Control
⑦ Select Decimal Return to
except final step.
Proportional band
point. (Middle temp.)
↓ Press Mode key final step. ↓ Press Mode key
⑧ Operation volume
Number of
Integral time
lower limit operation (middle temp.)
↓ Press Mode key ↓ Press Mode key ↓ Press Mode key
⑨ Operation volume
End Signal
Differential Time
upper limit ON time (middle temp.)
↓ Press Mode key ↓ Press Mode key ↓ Press Mode key
⑩SV limiter low Return to
See next page
↓ Press Mode key ⑫ start SV function
⑪ SV limiter high
↓ Press Mode key
Press Mode key
⑬ SV start
↓ Press Mode key
See next page ⑭
c) PTTN/STEP confirmation mode
f)Common Parameter setting mode
g)Parameter per Pattern setting mode
h) Control constant setting mode
e)PATTERN NUMBER SETTING mode
Keep on pressing RESET key for 3 seconds to change into
a)RESET mode from each mode of f)～i).
In case RUN Signal Input to be applied, please set "29.RUN
RUN/STOP key
RESET key(3 sec.)
RESET key(3 sec.)
RUN/STOP key
PTTN/STEP key
PTTN/STEP key(3 sec.)
Initial Display
(Indicates for 4 seconds)
□
□
□
□
□
□
PTTN/STEP key
To Next Page
Loading...