Tomar Scorpion
970L Lightbar
Operational & Programming Instructions
To activate the lightbar traffic direction programming mode:
GROUND the 10 AWG BLACK power wire.
Apply +12vdc to the 12 AWG RED power wire & the GRN control wire,
then apply +12vdc to the RED/WHT (Right Arrow) control wire.
NOTE: The Traffic Direction modes are (RED/WHT) Right Arrow, (BRN/WHT) Left Arrow and (RED/WHT +
BRN/WHT) Center Out. Only one Traffic Direction Mode, either Right Arrow or Left Arrow need be
programmed
to program the Traffic Direction Modes. Traffic Direction modes are only available when at least
six 970 LED modules are configured to the Rear of the 970L Lightbar.
Once Traffic Programming Mode has been entered, tap (apply and remove) the appropriate wire to advance
through the available traffic flash patterns and rates. Continue until the desired activation is selected.
Advancing Traffic Pattern Selection:
Tapping the WHT/BLK wire advances the DIRECTION patterns.
Advancing
Traffic Flash Rate Selection:
Tapping the WHT/BLK + WHT wire advances the DIRECTION Flash Rate.
To Exit Traffic Direction Mode Programming, remove power from all 970L power and control wires.
IS0537-02
06/21/2013
PHONE: 800-338-3133
FAX: 800-688-6627
2100 W OBISPO AVE
GILBERT, AZ 85233
WWW.TOMAR.COM
Page 3
TM
Programming Preemption Parking Brake Disable Function (Violet Wire)
To activate the lightbar preemption parking break disable programming mode
GROUND the 10 AWG BLK power wire.
Apply +12 VDC to the 12 AWG RED power wire & the GRN control wire.
Advancing the function of the VIOLET disable wire
Tap the 18 AWG RED wire to scroll through the available settings. The strobe lamp will
pulse 1, 2, 3, or 4 times to indicate the function selected.
1 pulse of strobe = Ground
2 pulses of strobe = +12v
3 pulses of strobe = Ground Latch
4 pulses of strobe = +12v Latch
Programming Directional Modes Using The Lightbar Control Cable
To Next Page
Loading...