How to fix optoelectronic filter if it does not work on Tool it Motorcycle Accessories?
To address a non-functioning optoelectronic filter in your Tool it Motorcycle Accessories, first, activate the solar charge by exposing the cell to light for 20 to 30 minutes. Next, ensure the potentiometer is set to the welding position, specifically between 9 and 13. Finally, inspect and clean the detectors if necessary.
What to do if the filter darkens and then lightens while welding with Tool it PROMAX LCD 9.13G?
If the filter in your Tool it Motorcycle Accessories darkens and then lightens while the welding arc is present, adjust the sensitivity to a higher setting.
Why does the Tool it Motorcycle Accessories filter stay dark after welding?
If the filter stays dark after the weld arc is extinguished or when no arc is present when using Tool it Motorcycle Accessories, adjust the sensitivity knob to the lowest position. Also, if the ambient light around the welding area is extremely bright, it is recommended to reduce the light level.
What to do if Tool it PROMAX LCD 9.13G Motorcycle Accessories has uncontrolled switching or flickering?
If you experience uncontrolled switching or flickering with your Tool it Motorcycle Accessories, check that the arc sensors are not blocked from direct access to the arc light.
Adjusting the helmet's sensitivity for different lighting and welding conditions.
Configuring the delay for the filter to return to clear state after welding.
Switching between welding and grinding modes using the external potentiometer.
Step-by-step instructions for removing and installing the outer protective lens.
Procedure for removing and installing the inner protective lens.
General| Brand | Tool it |
|---|---|
| Model | PROMAX LCD 9.13G |
| Category | Motorcycle Accessories |
| Language | English |
To Next Page
