Tool Shed TSSH05 - Functions

14
FUNCTIONS
Fuel Valve Control
The fuel valve opens and closes the
passage between the fuel tank and the
carburetor. The fuel valve lever must be
in the ON position for the engine to run.
When the engine is not in use, leave the
fuel valve lever in the OFF position to
prevent the carburetor ooding and to
reduce the possibility of fuel leakage.
Throttle Control
The throttle lever controls engine speed.
Moving the throttle lever makes the engine
run faster or slower.
Engine Switch
The engine switch enables and disables the
ignition system. The engine switch must
be in the ON position for the engine to
run. Turning the engine switch to the OFF
position stops the engine.
Choke Lever
The choke lever opens and closes the
choke valve in the carburetor. The closed
position enriches the fuel mixture for
starting a cold engine.
The open position provides the correct fuel
mixture for operation after starting, and for
restarting a warm engine.
Recoil Starter Grip
Pulling the starter grip operates the recoil
starter to crank the engine. Use this to start
the engine on your machine.
Feed Hopper
It is the opening into which all materials to
be chipped should be fed.
Chipped materials are discharged through
this opening. Deector can be attached to
the chute.
Deector Lever
Loosen it in the anti-clockwise direction to
adjust the discharge angle. Tighten it in the
clockwise direction.
Emergency Stop Button
This machine has an emergency stop
button that will shut down the machine
immediately if hit.
Micro-switch
This machine has a micro-switch that will
prevent the machine operating with the
cover open, or without the hopper or
discharge chute attached. This is to help
ensure user safety when operating.