Need help?Do you have a question about the Tool-Temp TT-181 and is the answer not in the manual?
General| Brand | Tool-Temp |
|---|---|
| Model | TT-181 |
| Category | Temperature Controller |
| Language | English |
Defines safety symbols like Danger, Warning, Caution, Note.
Specifies the general validity for all temperature control units from TOOL-TEMP.
Details the intended purpose and limitations of the temperature control unit.
Illustrates the front panel of the temperature control unit with numbered components.
Provides installation guidelines and physical dimensions of the unit.
Details the hydraulic and electrical connections required for the unit.
Information on voltage, frequency, and fuse rating for power connection.
Procedure for filling the unit with water and initial startup.
Procedure for operating the unit with heat transfer oil.
Explains the functions and indicators of the MP-888 temperature controller.
Guides through setting parameters for the MP-888 controller without flow control.
Describes how to adjust temperature for heating and cooling modes.
Procedure for draining the mould and disconnecting the consumer.
Explains the leak prevention function using vacuum mode.
Details the protection features for the pump motor.
Describes temperature limits and safety thermostat for heating.
Explains the function of the level switch and associated indicators.
Describes how temperature deviation is monitored and alarmed.
Explains the use of the horn for fault indication and warnings.
Guidance on checking the unit's general condition before maintenance.
Procedure for periodic cleaning of the temperature control unit.
Instructions for repairing defects using original spare parts.
Provides an overview and identification of major components and spare parts.
To Next Page
