Need help?Do you have a question about the Tool-Temp MP-888 and is the answer not in the manual?
General| Brand | Tool-Temp |
|---|---|
| Model | MP-888 |
| Category | Temperature Controller |
| Language | English |
Provides specific safety information for the controller and refers to the machine manual.
Describes the set value, actual value, and flow displays.
Details the function of program/arrow buttons and status LEDs (cooling, heating, sensor, etc.).
Details power supply connections and possible supply voltages.
Specifies temperature sensor types, connections, and signal inputs/outputs.
Provides information on controller type, series number, and software version.
Lists programs for units without flow measurement.
Lists programs for units with flow measurement.
Describes the controller display sequence upon startup (Software version, unit, flow).
Steps to navigate and select a controller program using arrow buttons.
Procedure to confirm and save the selected program.
Steps to enter the controller menu and move between parameters.
Procedures for adjusting parameter values and saving changes.
Handling of units with special programming (P100) and parameter labels.
Parameters for temperature limits, deviation, flow, and flow alarms (P1-P4).
Parameters for temperature unit, sensors, analog inputs, and outputs (P20-P33).
Parameters for PID control, cooling, capacity relation, and switching times (P38-P48).
Parameters for flow units, calibration, measurement points, and alarm limits (P53, P60-P67).
To Next Page
