10
rigging the mast (...)
In preparation to raise the mast you will need to attach the
striker bar to the bow of the hull.
the striker bar.
6
crossbeam, you will need to per drill 2 x 3.7mm holes in the
beam to screw the cleat on to.
NB: ensure the securing screw for the drum is tightly done up.
The striker bar can now be attached to the deck eyes on the
bow. The split pin must be fully bent back to secure the pin.
You may prefer to replace the split pins with rings for ease of
use.
side will face forward.
7
8
The mast can now be lifted back do the mast foot can be
inserted).
9
To Next Page
Loading...
