5
rigging instructions
setting up the hull
Fit the cross bar in the beam socket of each hull and align
them with the predrilled holes. Clean and grease the bolts,
the inner bolt for the rear beam are used with the big plastic
washers and the outer bolt with the smaller one.
Hand tighten the bolts while insuring that the tubes are
inserted in the bolts inside the beam.
Then tighten with 2 x 17mm spanners but not too much.
Retightening on a regular basis is necessary.
covers.
and slide the trampoline into the rail of the front beam until
it is central, this best done by 2 people to avoid snagging the
trampoline on the beam.
1
2
To Next Page
Loading...
