20
rigging the spinnaker kit (...)
To attach the pole to the boat insert the spike on the end of
the pole into the hole on the front cross beam just below the
2
The pole is suspended by a line tied to central strut of the
spinnaker if needed).
3
The dynema lines attached to the front of the pole are to
stop the pole being pulled up when sailing. In order to
tension these correctly the help of a second person is
needed.
Tie a loop approximately 2/3rds of the way down each line,
bow of each hull and back through the loop on each side.
With one person pushing the pole down slightly tension
Please note the pole should be kept centred between
the hulls.
4
5
To Next Page
Loading...
