14
attaching the main sheet (...)
rigging the jib
Feed the main sheet through the cleat (from the front to
back of the boat) on the traveller car and through the round
hole on the plate the main sheet is attached to.
The end of the mainsheet is then secured with a stopper
knot having been fed through the deck eye on the back of
the rear cross beam.
the cleat, this should stop between 5 and 10 cm short of the
end stop. If the car is hitting the end stop, move the position
of the knot to prevent this.
on the jib.
Attach the jib to the furler drum using the long tail of the
forestay (as close as possible to the drum) again leave a
long tail.
Attach the jib halyard to the webbing loop on the top (head)
of the jib sail with a bowline knot.
3
4
1
2
To Next Page
Loading...
