Topcon DT-209L User Manual

6
Laser Safety
DT-205L/207L/209L uses the visible laser beam. DT-205L/207L/209L prod-
ucts are manufactured and sold in accordance with “Radiation Safety of
Laser Products, Equipment Classification, Requirements and User‘s Guide”
(IEC Publication 60825-1) or “Performance Standards for Light-Emitting
Products” (FDA/BRH 21 CFR 1040) provided on the safety standards for
laser beam.
As per the said standards, DT-205L/207L/209L classified as “Class 2
(CLASS II) Laser Products”.
The laser beam belongs not very dangerous type but we request you to keep
and understand “Safety standard for users” as mentioned in the manual
instruction.
In case of any failure, do not disassemble the instrument. Contact TOPCON
or your TOPCON dealer.
Labels
Find the labels which describes the caution and safety about the laser beam
as follows in DT-205L/207L/209L. We request you to replace it one anytime
the caution labels are damaged or lost and paste a new one at the same
place. You can get the labels from Topcon or your dealer.
CLASSII LASER PRODUCTDIODE LASER
WAVE LENGTH 633nm
0.6mW MAXIMUM OUTPUT
CAUTION
LASER RADIATION
DO NOT STARE INTO BEAM
AVOID EXPOSUR
E
LASER LIGHT IS EMITTED
FROM THIS APERTURE
CLASS 3A @LASER PRODUCT
DO NOT STARE INTO THE BEAM OF VIEW
LASER RADIATION
DIRECTLY WITH OPTICAL INSTRUMENTS
Beam aperture
Depending on the country where the instrument is sold,
either of these labels may be found on the instrument.

Topcon DT-209L Specifications

General

Brand	Topcon
Model	DT-209L
Category	Laser Level
Language	English