34 FC-600 Field Computer Owner’s Manual
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit dierent from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
In compliance with the FCC rules, 47 CFR 15.21, the user must
be notified that changes or modifications to the Rugged Handheld
that are not expressly approved by the manufacturer could void the
user’s authority to operate the equipment.
Only approved accessories may be used with this equipment.
In general, all cables must be high quality, shielded, correctly
terminated, and normally restricted to two meters in length. Wall
chargers approved for this product employ special provisions to
avoid radio interference and should not be altered or substituted.
This device must not be co-located or operating in conjunction with
any other antenna or transmitter.
Industry Canada
This device complies with ISED licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired
operation of the device.
Any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to
operate this equipment.
In compliance with Industry Canada rules, the following statement
must appear on the device or in the user documentation:
This Class B digital apparatus complies with
Canadian ICES-003.
Radio Frequency Safety
This device has been evaluated for use in close proximity to the
body. Use only accessories approved by Topcon. The use of third
party accessories may not comply with FCC and international RF
exposure requirements. To comply with FCC and other national
To Next Page
Loading...
