ISOBUS ARTEMIS - SEED DRILL CONTROLLER
3
1
INTRODUCTION 5
1.1
System Overview 5
1.1.1
System Components ...................................................................................................................... 5
1.2
Artemis Main Functions 7
2.
MULTIPLE CHANNELS / PRODUCTS 8
2.1
Linked Channels 8
3.
OPERATION 9
3.1
Artemis Primary Screen Pages 9
3.2
The Main Operating screen - Summary 10
3.3
Channel Selection and Status 10
3.3.1
Switching Metering motor(s) On-Off / Manual Override / Half-Width Drilling ........................... 11
3.4
Work Status 11
3.5
Setting the Application Rate 12
3.5.1
Seed and fertiliser ........................................................................................................................ 12
3.5.2
Pellet/ Small seed Applicator ....................................................................................................... 12
3.6
Pre-start Sequence 13
3.7
Tramlining 14
3.7.1
Advancing the Bout Number ....................................................................................................... 15
3.7.2
Holding the Bout Number ............................................................................................................ 15
3.7.3
Setting the Tramline Rhythm ....................................................................................................... 15
3.7.4
Special Tramline Sequences......................................................................................................... 16
3.8
Forward Speed Display 16
3.8.1
Forward Speed Alarm .................................................................................................................. 16
3.8.2
Simulated Forward Speed ............................................................................................................ 16
3.9
Fan Speed Display 17
3.9.1
Set Fan Speed Alarms .................................................................................................................. 17
3.10
Hopper Level Alarms 18
3.10.1
‘Motor Inhibited’ Alarm ............................................................................................................... 18
3.11
Totals 18
4.
BLOCKAGE MONITORING (OPTIONAL) 19
4.1
Blockage sensor status and alarms 19
4.2
Blockage sensor alarm override 20
4.3
Sensor Calibration 20
5.
PRODUCT CALIBRATION 21
5.1
Running the test from the Cab 21
5.2
Running the test using the Priming Switch 22
5.3
Calibrating systems with ‘Accord’ type metering mechanisms. 23
6.
ALARM CODES 24
To Next Page
Loading...
