ISOBUS ARTEMIS - SEED DRILL CONTROLLER
4
ADDENDUM 1 - EZ-CAL EXTERNAL DISPLAY 30
1.
Overview 30
1.1
Kit Contents ................................................................................................................................. 30
2.
Installation 30
3.
Operation 31
3.1
Calibration Test ............................................................................................................................ 31
3.2
Calibration test started from UT .................................................................................................. 31
3.3
Calibration test started using the Prime Switch .......................................................................... 31
3.4
Calibration test started from the EZ-CAL display ......................................................................... 32
3.5
To view the Maximum Forward speed for each channel ............................................................. 32
3.6
Priming the metering unit before starting a calibration test ....................................................... 32
3.7
Diagnostics ................................................................................................................................... 32
To Next Page
