Topcon ISOBUS Artemis - Page 9

ISOBUS ARTEMIS - SEED DRILL CONTROLLER
7
1.2 Artemis Main Functions
The Artemis is designed to allow automatic, variable rate control of any drill. Also it can control an auxilliary Applicator
system e.g. for Slug Pellets etc. You can at any time manually override the predetermined rate as field conditions require.
The basic functions are:
 Variable Rate Control
 Tramline Control and Half Width operation
 Forward Speed Alarms
 Hopper Level alarm
 Fan Speed & alarm
 Information totals
The instrument has a special software routine that makes calibration of the metering unit(s) very easy. In the calibration
mode each metering unit is controlled via a ‘priming switch’ to dispense the product. During normal operation the control
system is started and stopped automatically via finger switch as the drill is put into and taken out of work.